Comments on: We Recently Had Underfloor Heating Installed In The Bathroom (wiring)?

By: Aggressive White Hat SEO

Aggressive White Hat SEO — Sat, 31 Oct 2009 09:41:57 +0000

What do you mean by ‘cement not drying on some of the tiles’ ? You should have used flexible tile adhesive and should have used bonding/primer on the concrete floor before laying the element. ‘Anything’ would have dried out in a week or so, if you have moisture present then there must be a leaking pipe somewhere??!

By: True Brit

True Brit — Sat, 31 Oct 2009 09:26:36 +0000

Did he use the correct cement? I say this, because my husband didn’t. He should have used a flexible cement. We’ve had to redo it.

By: SCORPIO

SCORPIO — Sat, 31 Oct 2009 05:05:51 +0000

I’m not sure if the cement is the problem. Perhaps he did not use enough to actually in-bed the tile into the floor. If the tiles keep popping up in some areas and not others, you know the cement is fine. Try to spread the cement on the tile and then lay it in place. I know from experience that not all tile pieces sit properly. Some are off even if they seem perfectly flat. I’m sorry I don’t have a miracle answer. We did our bathroom tiles and not all accepted the same amount of cement. Some needed to be wiggled in, others didn’t. Don’t go crazy yet, you will find the answer. Good luck and Merry X-mas.